Psion Teklogix PrintAbout MP2000 Manuale dell'Operatore Scaricare il pdf (Pagina 10)

Getting Started

Release Leve

Battery Contacts

Figure 2 - Battery Installation

To charge the battery, connect an optional power supply to the appropriate input source, and then connect the

output of the power supply to the printer’s Power Connector at the location shown in

Figure 3. The Battery

Indicator will turn on and remain on until the battery is fully charged. This may take up to 2½ hours.

Note: You must charge the battery for at least 2½ hours prior to the first use.

Caution: Use only Psion Teklogix power supplies designed specifically for your PrintAbout printer. Using a

different power supply may cause damage to the printer and will not be covered by the printer’s

warranty. Psion Teklogix power supplies are available for use with 100-240VAC/50-60Hz and

for12/24VDC vehicle applications.

Power Connecto

Batter

Indicato

Figure 3 - Power Connector & Battery Indicator

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 54 55

Nessun commento

Psion Teklogix PrintAbout MP2000 Manuale dell'Operatore Pagina 10